|
28/04/2013
- I'm another year older, I must finish this !!
That
list again !
 | Drill and ream rear spar
to correct size |
| Drill and ream fuel tank
mount |
| Fit wing flashings and
underside skin holes |
| Drill and shape holes
for flap rods |
| File flap skin edge to
make sure of clearance against fuselage once painted
|
| Nut plates for exterior
trim
|
The plans call for a peanut
shaped hole, but in the end it has to be quite a large peanut so
that nothing catches however the pushrod is positioned
I
needed to open the holes more than this in the end
Shot from below
Shot from the fuselage side. This still isn't
final size
 |
![[28042013] - Fuselage](_derived/[04282013]%20-%20Fuselage.htm_cmp_travel01_flash_v2010_bnr.gif){kind=small}
